I made these last year and have been enjoying them in my home. I have an older house that had gaudy gold light covers in every room. After seeing the finished product at a friends house, I was ready to tackle every room!
You will need:
Light switch covers
Scrapbook paper
Mod podge
Exacto-knife
I used an exacto-knife as I found it was easier to cut corners. You want to cut the page around the plate where you can just bend the corners over into the inside.
Cut out a tiny little triangle by each corner. Also cut an X inside the center where the lifht switch goes. This way when you fold the corners over, it's not overlapping and bulky.
Once you have the shape cut, mod podge the inside and place the switch plate on top with corners and sides bent inside.
After its dried, coat the outside with mod podge. I put about two coats on mine.
TaDa! Wonderful personalized covers made by you!
You will need:
Light switch covers
Scrapbook paper
Mod podge
Exacto-knife
I used an exacto-knife as I found it was easier to cut corners. You want to cut the page around the plate where you can just bend the corners over into the inside.
Cut out a tiny little triangle by each corner. Also cut an X inside the center where the lifht switch goes. This way when you fold the corners over, it's not overlapping and bulky.
Once you have the shape cut, mod podge the inside and place the switch plate on top with corners and sides bent inside.
After its dried, coat the outside with mod podge. I put about two coats on mine.
TaDa! Wonderful personalized covers made by you!
Comments
Post a Comment